Prev my images Prev

LCV: EDGE DETAILING


The LCV is a ploshing machine for producing polished stright edges 10 to 600mm thick marble and granite.

The working mode is on a continuous process basis; this means that all the pieces are loaded one after the other and move past a series of polishing heads one after another. The outcome is a fully polished flat edge.

In the LCV, the workpieces are placed vertical to the table. Because of this vertical placement, the area necessary for operation is reduced besides avoiding breakage of material and cluttering.

The LCV does not require a accomodation for discharging water. It has a discharge hose through which the dirty water can be directed to a pit or a channel.

This machine is capable of polishing straight flat-squared 1 to 6 cm thick marble, granite, or engineered stone edges at over 120 lineal feet per hour.






TECHNICAL DATA


Fully automatic straight edge polishing

Production speeds of 80 to 150 l/f per hour

No height restrictions for material being processed

7 polishing heads enables processing in one pass

Requires small foot print for set up and operation. (Dimensions are 14’x4’)

The LCV 711 requires no human intervention to over see the operation and allows the operator to do other jobs

Cost of lineal feet of finished edge amortized over 5 years is under .30 per foot

Over 3,000 LCV 711 machines in operation throughout the world

Machine has been in operation since 1982

Number of Polishing Motors: 7

Number of Beveling Motors: 2

Total Water Consumption: 12 to 15 gallons/minute

Total Power Requirement: 230v/3phase/60amps

Total Dimension of Machine: 10ft x 4ft x 4ft

Total Weight of Machine: 3,000lbs

Extension Tables: Standard 3ft in length

Working Speed: 150 Lineal feet per Hour

Maximum Abrasive Size: 6" or 150mm

Minimum material size: 3 inches x 16 inches (shorter pieces possible like 12" x 12" tile, contact us for details)

Maximum material size: NO MAXIMUM


CROSS TRAVEL STROKE                        3720 mm

LONG TRAVEL STROKE                          3600 mm

UP & DOWN STROKE                             300 mm

BLADE TILTS                                        UPRIGHT 90deg to MITRE 45 DEG

TABLE DIMENSIONS                             3200 X 1800 mm

BLADE DIAMETER                                 RECOMMENDED 450 (MAX 550)

BLADE SHAFT DIAMETER                       60 mm

MOTOR RATING                                    18HP

POWER RATING                                    415V 3PH 32AMP 50HZ


HYDRAULIC TILTING TABLE HORIZONTAL TO 80 DEG SLANT

LINE LASER TO LINE UP YOUR CUTS

PNEUMATIC HEAD TILT

CENTRALISED HAND LUBRICATION



Copyright © Farnese Australia 2016